Instruction Manual – TECNO Spark Power 2

Review TECNO Spark Power 2 – TECNO SPARK Power 2 has a 7-inch screen with a resolution of 1640 x 720 pixels. The screen uses IPS LCD panel type.

The TECNO SPARK Power 2 rear camera uses a quad-camera rendering module with quad flash, where the configuration is 16MP for wide lenses, 5MP for ultrawide lenses, 2MP for macro lenses, and QVGA sensors for lens depth.

Furthermore, the front camera of the device uses a 16MP dual flash sensor which is claimed to have a very good sensitivity level so that it can provide good quality selfie photos with a maximum angle of 78 degrees.

TECNO SPARK Power 2 is powered by a MediaTek Helio P22 SoC processor with a GPU PowerVR GE8320. The processor is then combined with 4GB of RAM memory and 64GB of internal storage.

The battery is the main selling point of the TECNO SPARK Power 2 because the phone has a capacity of 6,000 mAh and already supports 18W fast charging. Tecno Mobile claims that cell phones can charge up to 50% in just 60 minutes. Apart from that, the cellphone can last for 4 days in standby mode.

For the matter of features, this phone is equipped with Wi-Fi 802.11 b / g / n / ac, Bluetooth 5.0, and GPS. Specifically for security, TECNO SPARK Power 2 has not used a fingerprint sensor embedded in the screen but the sensor is on the back body of the device.

TECNO SPARK Power 2 is an Android 10 based phone with HiOS 6.1 interface. At present, TECNO SPARK Power 2 can only be used for the 4G LTE standard network.

User Guide Pdf is not available yet

TECNO Spark Power 2 Support